1970 Mustang Mach1 World Registry Forum

Welcome to the 1970 Mustang Mach1 World Registry this forum is open to all 1970 Mach1 owners & enthusiast around the world.
 
HomeHome  FAQFAQ  SearchSearch  RegisterRegister  MemberlistMemberlist  UsergroupsUsergroups  Log inLog in  

Share | 
 

 Quarter Panel Side Marker Light Hole Location [b]--HELP--[/b

View previous topic View next topic Go down 
AuthorMessage
Alan_MacDougall
New Member


Number of posts : 6
Registration date : 2010-02-14

PostSubject: Quarter Panel Side Marker Light Hole Location [b]--HELP--[/b   Tue 16 Feb - 22:04

I recently had both full quarter panels replaced and we just noticed the side maker holes were not cut in the Dynacorn panels. Crying or Very sad We can get the hole size and the vertical height location off the old panels but we need the horizontal location measurements from an original panel. Please can someone measure accurately with a straight edge from the rear edge of the light housing or (better from the hole) to the of the edge of the quarter panel undercut for the bumper? Since this undercut edge is on an angle, I need two measurements , a) at the top b) at the bottom of the light housing or hole. Another method would be to use tracing paper and trace the hole and the edge and send it to me. HELP! I have to get the holes located correctly. any other suggestions? Alan 503 352-4930
Back to top Go down
View user profile
brick70
Mach1 Addiction


Number of posts : 52
Registration date : 2008-04-03

PostSubject: Re: Quarter Panel Side Marker Light Hole Location [b]--HELP--[/b   Wed 17 Feb - 9:32

Hello, One way if you haven't trashed your old qtrs is to cut out the piece that has the opening and use it as an overlay to cut out the square. Be very careful it's better to cut it out a little smaller and file it later than to cut it to big and have cracks exposed outside the bezel.
Back to top Go down
View user profile
Alan_MacDougall
New Member


Number of posts : 6
Registration date : 2010-02-14

PostSubject: Re: Quarter Panel Side Marker Light Hole Location [b]--HELP--[/b   Wed 17 Feb - 11:37

The old panels were cut to the left and right side of the holes such that there is no horizontal reference point. I can use the holes for vertical location and size. Alan
Back to top Go down
View user profile
Sponsored content




PostSubject: Re: Quarter Panel Side Marker Light Hole Location [b]--HELP--[/b   

Back to top Go down
 
Quarter Panel Side Marker Light Hole Location [b]--HELP--[/b
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» rear quarter panel and back seat removel?
» Rear quarter panel replacement
» 2nd Gen Chevy side marker lights question???
» quarter panel fix?
» Previously Sold Parts

Permissions in this forum:You cannot reply to topics in this forum
1970 Mustang Mach1 World Registry Forum :: DISCUSSIONS :: Tech Discussion (Q&A), Problems, Fixes. etc..-
Jump to: